Hi - Tenlog TLD3-Pro, printing with branx new Overture PLA+, printing an OpenSCAD exported STL sliced with Cura 5.7.1 (most recent as of yesterday).
I'm printing first level at 0.3mm thickness, but the print is irregularly too thick in height -- and not by a little bit, a lot. I've lowered the temperature to 190. I've physically lowered the bed to the point that the skirt didn't print, then raised it just barely back. I've reduced the flow rate to 85%, and I'm still getting the same results. I've lowered the build plate temperature, no change.
The skirt might be a tough high in spots, but I'm ending up with the first level of a prime tower that looks like this.
Any ideas? What else can I try?
is your printer calibrated? if this isnt a badly leveled bed, it could be something like a crooked Z axis.
at least part of it is looking like the nozzle might be way too close, from this angle.