Rutty

Release the dragonflies

Awesome. Thank you

Nice! I have thought about doing something like this, but haven’t yet.

Would you mind if I asked you how you transferred the drawing to 3D? I use fusion360, and the process can be a bit finicky.

Ideally I would like to take a drawing and convert it into a stamp

Something something net neutrality?

As an aging millennial, I am surprised by how the process of time works.

Like you spend your life acquiring skills and using your knowledge in an ever expanding cornucopia of experiences.

Then followed by a gradual decline to be left only with your memories of who you once were. But then you realize you were only a small part of the existence of others, and ultimately the universe. Yep, the thought of faculties diminishing over time is enough to put the one into an extensional crisis.

Oh yea, well explain to me how Pete Rose was banned for gambling and Shohei Ohtani didn’t even receive a reprimand.

Yea. Like I want to talk about baseball. There’s like three people here that have a similar interest and there are all following different teams

I think these are the settings, used a 0.6mm nozzle

I sure hope not. Harris is a sure fire way to a Trump presidency.

How about Mark Kelly?

PETG is holding up fine. Both these and the couple I printed last year are still going strong. ABS is good as well. PLA is brittle, but gets the job done. I wouldn’t recommend this material for something you want outside more than 3-4 years (at least with my weather).

My angle is probably a bit different.

You can probably find the files on myminifactory as well. Search Menippus