The printer.cfg is highly dependent on your setup. For reference you can look at the example config for the SKR mini e3 v3: https://github.com/Klipper3d/klipper/blob/master/config/generic-bigtreetech-skr-mini-e3-v3.0.cfg
B0rax
Well. Why would you want to do that?
In the end, choose the board that has the features you need. Software is the same anyway.
With Klipper you can even combine multiple boards to get the features you want.
Ja, und? Früher hab ich auch so „viel“ gespielt. Hat niemandem geschadet.
That sound like it would wobble and easily tip over, no?
PA is also way too low (if it is even set at all). It could reduce the „thickening“ of the lines at each end dramatically.
Naja gut. Das könnte man auch damit begründen, dass die Lohnkosten in Deutschland höher sind, und dadurch natürlich die Kosten pro Fahrzeug höher sind als bei Fahrzeugen aus anderen Ländern
Alles über 0% Gewinn ist doch erstmal in Ordnung. Verstehe immer das Problem nicht wenn der Gewinn nicht gewachsen ist.
So these are blocked on a DNS Level? So just using a different DNS (like 9.9.9.9 or 1.1.1.1 or 8.8.8.8) will get around this „block“
If a car drives more than 60.000 km in its lifetime, a battery powered vehicle will be more environmentally friendly. With every additional kilometer driven, it will be better than combustion vehicles.
Sure, driving less is always better.
You happen to have a link for that? Sounds very interesting
Jokes on them, windows is and has been my secondary OS for years now. If it causes problems, I have no problems just deleting it.
So how would that work? You can not distinguish between commercial or private use, because the traffic is encrypted, you don’t know what is transmitted, that is the whole point.