I was planning to set transcoding on the M.2 by using a Pi M.2 Hat board. However, since the M.2 is already there, should I just use it to run the OS and downloads, too, or just use it as a transcoding consumable and media drive? This Pi 5 has 16Gb of RAM, so it might handle every bit of the transcoding regardless, but I have not tested it. I'm also concerned about latency between the main Pi board and the hat, connected with a flexible circuit board cable.

Also, anyone have issues with media storage on external drive when using Plex/media servers?

Equipment has been ordered but has not been delivered yet. Should come the next few days.

you are viewing a single comment's thread
view the rest of the comments

[–] drastico@lemminielettrici.it 2 points 9 hours ago

With yunohost I have never burnt any sd, even if I got some blackouts.

The reason why (probably): paying for a good quality big one. One of those 256GB and premium tier (sorry I don’t remember the codes on them but you can easily check them)

Nonetheless, I have 3 backups of that data tho. If it’s just about “using” it I wouldn’t worry. If you wanna stack films series etc, backup on hard drives :)